Project flow chart

STEP 1 - DATA INPUT STEPS

• Collection of input data from the Customer
• Check if all the input data required are present and consistent
• Iteration until the complete definition of the input data
• End input data steps

STEP 2 - DATA INPUT ANALYSIS

• Analysis input data collected
• Choice of optimal typology
• Verification of compliance with the performance, electrical and mechanical.
• Verification of Standards regulations, safety and EMI
• End data analysis steps

STEP 3 - DESIGN SIMULATIONS

• Simulations of typology performances
• Electrical simulations
• Thermal and electromagnetic simulations
• Verification of simulations results
• End simulations steps

STEP 4 - DEFINITION MAGNETIC COMPONENTS

• Select typology of magnetic components, from available product range
• Preliminary magnetic components design
• Check calculation results, have to be compliance with the input requirements
• Design definition of selected magnetic components
• If unavailable magnetic components, from standard product range, jump to the â�¨next step

STEP 5 - DEFINITION MAGNETIC COMPONENTS

• Design a new magnetic component
• 3D design
• Fast prototyping samples
• Test samples performance
• End definition magnetic components

STEP 6 - POWER SUPPLY DESIGN

• Design schematic diagram, based on simulations results
• Design the EMI filter
• Design PCB to comply to safety creepage and clearance distance
• Verify compliance with mechanical and electrical design requirements
• Define BOM

STEP 7 - POWER SUPPLY DESIGN

• Assembly of components on the PCB

STEP 8 - POWER SUPPLY DESIGN

• Define a setup of measures
• Test and debug power supply
• Check load and overload conditions
• Check thermal conditions
• Iterate until the requirements of the â�¨project are satisfied
• Generate the measure report, to â�¨compile the technical documentation
• End design procedure

STEP 9 - EMI PRE-COMPLIANCE MEASURE

• Define a setup of measures
• EMI conducted measure
• If needed re-design the EMI filter and/or PCB layout
• Iterate until the requirements of the project are satisfied
• Generate the measure report, to compile the technical documentation
• End EMI pre-compliance

STEP 10 – ISSUING TECHNICAL REPORT

• Issuing technical report
• Deliver demoboard, magnetic components sets, technical report
• End project